Forum Post: RE: How to exclude LAN911x code from BSP_WINCE_ARM_A8_01_02_00

Thanks Carsten,
After disabling KITL the error message during OS load doesn't show any more. I don't know if my OS image loads fine because have no display connected at the moment and without KITL I see no more debug messages.
However when selecting the menu option 1 (show settings) in EBOOT we still see LAN911x and corresponding error.
Any more ideas on how to neatly clear that up ?
And how do I reassign KITL to another I/O channel (like UART) ?

  Boot device:   NK from SDCard FILE
  Debug device:  LAN9115 MAC
  Retail Msgs:   disabled
  Device ID:     0
  Display Res:   DVI  800x480 60Hz
  Flashing NK.bin:   disabled
  OPP Mode:   MPU[1000Mhz @ 1.375V], IVA2[800Mhz @ 1.375V]

 SDCard:
  Filename:      "nk.bin"
ERROR: C:\WINCE600\PLATFORM\COMMON\SRC\SOC\COMMON_TI_V1\COMMON_TI\BOOT\LAN911X\.\lan911x.c line 657: Invalid Ethernet chip ID (0xffffffff)!

 Network:
  KITL state:    enabled
  KITL type:     active
  KITL mode:     interrupt
  DHCP:          enabled
  IP address:    0.0.0.0
  IP mask:       0.0.0.0
  IP router:     0.0.0.0
  Eth MAC Addr:  20:20:40:30:60:50 (Boot settings)
  VMINI:         enabled
  Note: USBFN RNDIS MAC Addr cannot be changed.

Thanks Carsten,
After disabling KITL the error message during OS load doesn't show any more. I don't know if my OS image loads fine because have no display connected at the moment and without KITL I see no more debug messages.

However when selecting the menu option 1 (show settings) in EBOOT I still see LAN911x and corresponding error.
Any more ideas on how to neatly clear that up ?
And how do I reassign KITL to another I/O channel (like UART) ?

  Boot device:   NK from SDCard FILE
  Debug device:  LAN9115 MAC
  Retail Msgs:   disabled
  Device ID:     0
  Display Res:   DVI  800x480 60Hz
  Flashing NK.bin:   disabled
  OPP Mode:   MPU[1000Mhz @ 1.375V], IVA2[800Mhz @ 1.375V]

 SDCard:
  Filename:      "nk.bin"
ERROR: C:\WINCE600\PLATFORM\COMMON\SRC\SOC\COMMON_TI_V1\COMMON_TI\BOOT\LAN911X\.\lan911x.c line 657: Invalid Ethernet chip ID (0xffffffff)!

 Network:
  KITL state:    enabled
  KITL type:     active
  KITL mode:     interrupt
  DHCP:          enabled
  IP address:    0.0.0.0
  IP mask:       0.0.0.0
  IP router:     0.0.0.0
  Eth MAC Addr:  20:20:40:30:60:50 (Boot settings)
  VMINI:         enabled
  Note: USBFN RNDIS MAC Addr cannot be changed.