Hi Team, I am working on EVMK2E V1.0.2.2 board I got this board and I found that by default this version of EVMK2E will boot U-boot from SPI NOR and Kernel, File system from NAND. ******************************************************************************************************** Now I want to boot U-boot and other kernel images which I build through Yocto Arago Project. I tried to Boot throug CCS software with XDS200 JTAG Emulator support I followed the instructions mentioned in the User Guide in the link http://processors.wiki.ti.com/index.php/MCSDK_User_Guide_for_KeyStone_II and in the link : http://processors.wiki.ti.com/index.php/MCSDK_UG_Chapter_Exploring#Installation_Guide to install CCS. I installed CCSv5(ccs_setup_5.5.0.00077) in Windows 7 64 bit PC successfully. Once after installtion is done i installed the "ti_emupack_keystone2_setup_1.1.1.0". ****************************************************************************************************** Once CCS installation is done, I powered on the EVM board, Once after BOOT COMPLETE message is displayed in EVM LCD I opened CCS appplication and followed the below steps from http://processors.wiki.ti.com/index.php/MCSDK_UG_Chapter_Exploring#Loading_and_Running_U-Boot_on_EVM_through_CCS and I loaded the U-boot and I verified the PC register also. But when I click "Resume" it got crashed and u-boot prompt didn't turn up. I attached the file "corruption.txt" for reference Then I realised I didnt set the DIP Switch to No boot mode/JTAG DSP Little endian and I did the above steps with SPI NOR ARM Master boot So I changed the DIP switch to No boot mode and I turned on EVM and CCS But when I tired to connect the Target this time. I got the below error message Error connecting to the target: Connect to PRSC failed And after this I couldn't able to connect to the Target(Texas Instruments XDS2xx USB Onboard Emulator_0/arm_A15_1) in No Boot Mode I can able to launch the Target configuration but i couldn't able to connect the target alone But in "SPI NOR ARM Master mode" I can able to connnect to the Target ( Texas Instruments XDS2xx USB Onboard Emulator_0/arm_A15_1 ) I need to to boot U-boot through CCS. So please help me with this. I installed CCSv6 and tried and it also gives the same issue. (Please visit the site to view this file)
↧