Good day,
I 've bought used Asus P526 mobile with Windows Mobile 6.1 on it, but after battery discharged, it turned off and didn't turn on. i connected a USB cable. then after first boot i got a message - "IPL: Insert USB Cable"
so i tried to charge it for few hours, reset it, restart - same - nothing! same msg - IPL: Insert USB Cabl
so i tried to change firmware - still nothing good!
finally, i remembered that once i got into this "service menu". but found on forum that i can get into it by pressing "OK + camera + reset" while removing "Hold button"...
so, i think i pressed exactly these three buttons (by memory, though, maybe three others, butsu rely with camera and reset), and ! yes! device started up! windows loaded!
but i tried to check if it will work well.. so turned off, and...
again - got same IPL: Insert USB Cable =-(
so i tried again to enter into this "service menu"... but instead i got real service menu (no black screen),
Main menu
(1) Show current settings
(2) Select boot device
(3) Select Debug device
(4) Network settings
(5) Nand/Nor/Mdoc Flash
(6) Save settings
(0) Exit and continue
and not ms windows... =-(
so is it a problem with boot device?
i see that now it is set to :
"
Selection (actual ipl from do(c?):
Debug device set to USBFn RNDIS
"
how to make windows running as before?
what is this USBFn RNDIS ?
what is ipl from doc?
why i see always -
IPL: Insert USB Cable
?
actually joystick is not working (on left top - it can't press button up - but up+reset is needed to hard-reset...)
so it seems that joystick_up+reset are being pressed "automatically" but i don't need it...
can i change this settings by software?