I compared our schematic vs the IA-EVM 1.2A schematic as far as the Ethernet port TLK110 and I cannot see any differences. There are differences in that the rest of the AM3359 pins follow the ICE v1 board not the IA-EVM, but I am using the unmodified IA-EVM pinmux config assuming that it would work for the pins on the Ethernet. But there is no ETH0_MDC MDIO clk (TLK110 pin31), but on the IA-EVM I see 1MHz clock on the MDIO clk after the init code is run. On our board the pin 31 goes lo and stays lo after the init code is run.
↧